Question 1

20 seconds after G1 tripped, G2 begins overloading as it attempts to absorb G1's load. G2's frequency is dropping. The power management system (PMS) is attempting to auto-shed non-essential loads. The DPO has confirmed that DP2 WCF may not be maintained if G2 also trips.

What is the DPO's priority action at this point?

Accepted Answer

Inform the master immediately, declare a DP Alert, begin controlled manual thruster reduction on the most loaded thrusters to reduce electrical demand and help stabilise G2, while simultaneously monitoring position At this point the scenario is escalating — the DPO cannot wait for automated systems to resolve it. The master must be informed immediately (this is now a DP Alert situation). Controlled manual reduction of thruster demand on the highest-loaded thrusters removes electrical load while preserving position-keeping capability better than an across-the-board minimum power command (which removes all fine control). Closing the bus in a G2 overload situation is the worst possible action — a fault propagating from G2 would then take out all power simultaneously. The PMS may not shed enough load fast enough; DPO manual intervention is appropriate.

Question 2

EMERGENCY SCENARIO — DP2 PLATFORM SUPPLY VESSEL

Vessel: Offshore PSV, DP2 class. Location: 80m from a fixed gas platform, holding position to deliver equipment. DPO on watch. Three DGNSS references active, two gyros operational (Gyro 3 offline for calibration). Sea state: 1.8m, wind 22 knots SW. Thruster configuration: full complement, open bus, consequence analysis test passed 90 minutes ago.

Work through the following 10 decision points in sequence — each builds on the last.

--- POINT 1 OF 10 ---

Without warning, the main generator (G1) trips offline. The DP system sounds an alarm. The bus is still open. The remaining generators (G2, G3) are online and picking up load. Position is currently stable.

What is the DPO's first action?

Accepted Answer

Immediately check the power status panel to confirm which generators are online, verify the bus is still open, and assess whether the remaining power configuration still meets DP2 WCF requirements in the current conditions The DPO's immediate response to any system alarm is active assessment — not passive waiting. Waiting for auto-restart risks losing 30 seconds of situational awareness during which the power situation may worsen. Closing the bus tie immediately is the most dangerous response — it connects both power sections and creates a common cause failure risk. Waiting for the engine room assessment before taking DP action passes decision authority to a team who cannot see the DP system status. The DPO must immediately understand what power is available and whether DP2 capability is maintained with the current thruster configuration and reduced generation.

Question 3

G2 trips. Only G3 remains online. G3 alone cannot power all thrusters at current demand. The vessel is 80m from the gas platform. Position has not yet moved but the DP system is reducing thruster power automatically as G3 struggles with load.

What is the single most critical action the DPO must take RIGHT NOW?

Accepted Answer

Immediately alert the gas platform via radio that the vessel has lost main power and may lose position At 80m from a gas platform with imminent loss of DP capability, the highest priority is warning the platform immediately. If the vessel loses position, the platform team must know NOW to initiate their own emergency procedures, clear the area, and prepare for a possible collision. Attempting to restart generators takes time and attention away from the primary safety communication. Switching to joystick with G3 overloading will not maintain position — there is insufficient power. Increasing thrust demand with G3 already struggling will only hasten G3's trip. The platform alarm call is the action that can save lives even if the vessel cannot save its own position.