Question 1

You notice unusual resistance or an odd noise when a side shell door is being raised or lowered during routine hauling operations. What should you do?

Accepted Answer

Report it immediately to the officer in charge, even if the door still appears to operate normally afterward Mechanical wear in a stressed component like a shell door's drive shaft or coupling doesn't always announce itself clearly before it fails — an early, minor anomaly can be the only warning available before a serious failure. Reporting it immediately, even if the door seems to keep working fine, gives the vessel a chance to catch a developing fault before it becomes a catastrophic one.

Question 2

You're asked to test a deck crane grab after electrical repairs nearby. As the grab is hoisted, what should have happened first?

Accepted Answer

The area within the grab's swing radius should be cleared of personnel before the lift On the bulk carrier Fairfield Eagle, a crew member working nearby was struck and fatally injured when a grab being test-lifted after repairs swung unexpectedly. The investigation found the area should have been cleared and barriered before the test lift began.

Question 3

A toolbox talk held before a lifting operation should explicitly cover which of the following?

Accepted Answer

Who must remain clear of the exclusion zone while the lift takes place A toolbox talk exists to make sure everyone present understands the danger zones, the abort signal, and — critically — who must not be in the area while the lift happens. The RMIMA investigation into the Fairfield Eagle fatality found the toolbox talk had not made this clear.